- This topic has 1 reply, 2 voices, and was last updated 1 year ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
when addpath the braph2 into matlab, it will be a pop-pup warning: the ONNX Converter matlab addon did not install. And Matlba will suddenly get stuck.
Hi,
Thanks for bringing this to our attention. Please click on the “X” button in the top-right corner of the pop-up warning window, as shown in the attached figure, to close it. This will allow the program to proceed to launch the landing GUI of BRAPH2. Let me know if you need any further assistance.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.